FRRA - Artículos en Revistas

Browse

Now showing 1 - 1 of 1

Determination and Analysis of Residual Stresses Induced by High Speed Milling Using a Micro-indent Method
(2018-06-15) Vottero, S.; Mammana, C. A.; Guidobono, A. P. M.
Abstract: The purpose of this work is to determine and analyze residual stress normal components and anisotropy degrees introduced by high-speed milling in specimens of AA 6082-T6 and AA 7075-T6 aluminum alloys. At each machined sample, the climb and conventional cutting zones were evaluated and compared. This paper includes a comprehensive study of thermal and mechanical effects associated with the residual stress introduction. For normal components determination, an optimized micro-indent method was used. Each measurement sequence from this approach was performed using a high accuracy measuring machine and classified according to thermal deviations measured. The residual displacements were determined with an absolute error down to ±300 nm. The normal components analysis allowed to infer the strong influence of the rolling process previous to high-speed milling and besides, the stress levels associated with thermal effects (higher in AA 7075-T6). Finally, the lower residual stress anisotropy degrees in both materials observed in the conventional cutting zone would indicate more homogenous local plastic stretching in this region for all planar directions.