FRCU - GIS: Grupo de Ingeniería de Superficies - Artículos
Permanent URI for this collectionhttp://48.217.138.120/handle/20.500.12272/812
Browse
2 results
Search Results
Item Characterization of DLC coatings over nitrided stainless steel with and without nitriding pre-treatment using annealing cycles(2019-04-02) Dalibón Bähler, Eugenia Laura; Czerwiec, Thierry; Trava-Airoldi, Vladimir Jesús; Ghafoor, Naureen; Rogström, Lina; Odén, Magnus; Brühl, Sonia PatriciaAmorphous hydrogenated diamond-like carbon (DLC) coatings were deposited using plasma assisted chemical vapour deposition (PACVD) on precipitation hardening (PH) stainless steel. Plasma nitriding has been used as pre-treatment to enhance adhesion and mechanical properties. Chemical and mechanical properties of DLC coatings are dependent on the hydrogen content and so on the relation between sp3 /sp2 bondings. The bondings and the structure of the DLC film change with temperature. In this work, a study of the thermal degradation and the evolution of the mechanical properties of DLC coatings over PH stainless steel have been carried out, including the effect of an additional nitrided layer. Nitrided and non-nitrided steel samples were subjected to the same coated in the same conditions, and they were submitted to the same thermal cycles, heating from room temperature to 600 C in several steps. After each cycle, Raman spectra and surface topography measurements were performed ◦ and analyzed. Nanohardness measurements and tribological tests, using a pin-on-disc machine, were carried out to analyze variations in the friction coefficient and the wear resistance. The duplex sample, with nitriding as pre-treatment showed a better thermal stability. For duplex sample, the coating properties, such as adhesion, and friction coefficient were sustained after annealing at higher temperatures; whereas it was not the case for only coated sample.Item Comparación del comportamiento al desgaste de un acero AISI 1045 nitrurado y seguido de un temple por inducción(2016-10) Schierloh, Gonzalo José; Regis, Matías Sebastián; Charadía, Raúl; Dalibón Bähler, Eugenia Laura; Brühl, Sonia PatriciaSe estudió el comportamiento al desgaste del acero AISI1045 con un tratamiento de nitruración iónica y posterior temple por inducción. Se midió dureza en superficie y perfil en profundidad. Se analizó la microestructura y evaluó el comportamiento al desgaste. Como resultado de la nitruración se obtuvo una zona formada por una capa de compuestos seguida por una zona de difusión de nitrógeno. La dureza superficial del acero templado y revenido aumentó en un 50% y, con el temple por inducción posterior, resultó aún superior con incremento en la dureza del núcleo. El comportamiento al desgaste resultó mejor que la del acero sólo nitrurado, debido al incremento de la capacidad de soporte de carga del sistema.