FRCU - GIS: Grupo de Ingeniería de Superficies - Artículos

Permanent URI for this collectionhttp://48.217.138.120/handle/20.500.12272/812

Browse

Author: search.filters.author.Escalada, Lisandro

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Contact fatigue behavior of α-Al PROOF 2 O -Ti(C,N) CVD coated WC-Co under dry and wet conditions
    (2020-11-07) Sosa, D.A.; Collado Ciprés, Verónica; García, José Luis; Dalibón Bähler, Eugenia Laura; Escalada, Lisandro; Roa, Joan Josep; Soldera, Flavio; Brühl, Sonia Patricia; Llanes, L.; Simison, Silvia
    The response to cycling contact fatigue load of a WC-6%Co carbide coated with a Ti(C,N)/α-Al2O3 CVD multilayer was investigated in dry and wet conditions. Imprints in dry conditions were characterized by small thin cracksformingacircumferenceatthemaximumradiioftheimprint.Thedamagedcoatingwastotallypresentin thefinalimprintofthedrytest.Wetindentationsshowcaseanareaintheimprintwherethe α-Al2O3 layerhas beenremovedthroughoutaringbutwaskeptatthecenteroftheindentation,suggestingthatthecoatingdamageundercyclingcontactloadinwetconditionsisdominatedbyα-Al2O3degradation,associatedwithafretting effectortangentialloadsacceleratingthefatigue-corrosionofthealuminalayer.
  • Thumbnail Image
    Item
    Corrosion behaviour of a SiOxNy coated and nitrided ph stainles steel
    (Elsevier, 2015) Dalibón Bähler, Eugenia Laura; Moscatelli, Mauro Nicolás; Simison, Silvia; Escalada, Lisandro; Cabo, Amado; Lasorsa, Carlos; Brühl, Sonia Patricia
    Precipitation hardening stainless steels are used in applications where wear and corrosion resistance are required. To improve the surface properties, thermochemical treatments in combination with hard coatings can be used. In this work, the corrosion behaviour of SiOxNy coatings deposited on nitrided and non-nitrided Corrax® PH stainless steel were evaluated comparing them with the behaviour of samples which were only nitrided (two different conditions of nitrogen percentage in the working gases were used). The microstructure was analyzed. Corrosion behaviour was evaluated by the Salt Spray Fog Test and cyclic potentiodynamic polarization in NaCl solution. Erosion-corrosion tests were conducted. The thickness of the coating was about 1.4 microns, and its hardness was 2300 HV. The film had better erosion and corrosion behaviour when it was deposited on the nitrided steel. This fact demonstrated that the nitrided layer results in a good interface that improves the adhesion and mechanical support.