FRCU - GIS: Grupo de Ingeniería de Superficies - Artículos

Permanent URI for this collectionhttp://48.217.138.120/handle/20.500.12272/812

Browse

Subject: search.filters.subject.Corrosion

Search Results

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Tribological and corrosion Behavior of Duplex Coated AISI 316L using plasma based ion implantation and deposItion
    (2020) Vaca, Laura Silvia; Quintana, Juan Pablo; Vega, Daniel; Márquez, Adriana Beatriz; Brühl, Sonia Patricia
    The implementation of a duplex process, which combines plasma nitriding with hard coatings obtained by cathodic arc, on stainless steel substrates has faced adhesion problems that affected the wear and corrosion behavior of the treated surfaces. One variation of the cathodic arc process, which could improve the adhesion, is its combination with plasma ion implantation. This work presents results of the wear and corrosion behavior of duplex TiTiN bilayer coatings obtained by cathodic arc deposition combined with ion implantation (PBII&D) on plasma nitrided AISI 316L stainless steel In order to compare the application of PBII&D in duplex processes against conventional cathodic arc deposition, other two types of samples were obtained; one group of samples was coated using the same experimental device with the substrate at floating potential and the other one with a commercial PVD system. The coatings were characterized by SEM, XRD, and nanoindentation. The adhesion was evaluated by the Scratch Test and Rockwell C indentation. The wear resistance was analyzed by the pin-on-disk test and the corrosion behavior was evaluated by means of anodic polarization tests in NaCl solution, as well as by the Salt pray Fog Test. The PBII&D bilayer coatings showed better adhesion while the commercial PVD TiN coatings presented the smallest wear volume loss, but the delamination inside and around the track evidenced adhesion problems. Corrosion resistance was improved in all coatings benchmarked against nitride substrates, but PBII&D processes offered better protection.
  • Thumbnail Image
    Item
    Corrosion behaviour of a SiOxNy coated and nitrided ph stainles steel
    (Elsevier, 2015) Dalibón Bähler, Eugenia Laura; Moscatelli, Mauro Nicolás; Simison, Silvia; Escalada, Lisandro; Cabo, Amado; Lasorsa, Carlos; Brühl, Sonia Patricia
    Precipitation hardening stainless steels are used in applications where wear and corrosion resistance are required. To improve the surface properties, thermochemical treatments in combination with hard coatings can be used. In this work, the corrosion behaviour of SiOxNy coatings deposited on nitrided and non-nitrided Corrax® PH stainless steel were evaluated comparing them with the behaviour of samples which were only nitrided (two different conditions of nitrogen percentage in the working gases were used). The microstructure was analyzed. Corrosion behaviour was evaluated by the Salt Spray Fog Test and cyclic potentiodynamic polarization in NaCl solution. Erosion-corrosion tests were conducted. The thickness of the coating was about 1.4 microns, and its hardness was 2300 HV. The film had better erosion and corrosion behaviour when it was deposited on the nitrided steel. This fact demonstrated that the nitrided layer results in a good interface that improves the adhesion and mechanical support.