UTN- FRC -Producción Académica de Investigación y Desarrollo
Permanent URI for this communityhttp://48.217.138.120/handle/20.500.12272/1932
Browse
8 results
Search Results
Item Synthesis, characterization and hydrogen storage application of an activated carbon derivated from orange peels waste(2022) Juárez, Juliana María; Ledesma, Brenda Cecilia; Anunziata, Oscar Alfredo; Gómez Costa, Marcos Bruno; Beltramone, Andrea RaquelThe recovery and reuse of orange peel waste (OP) is a sustainable strategy in a circular economy. In this research, OP was used as the raw material for the preparation of a novel carbonaceous nanomaterial to be used in the adsorption of hydrogen as an alternative in the use of green hydrogen. Activated carbons were synthesized from orange peel using different synthesis conditions. The activation of the carbon was carried out by means of a chemical process with phosphoric acid as activating agent, varying the the activating agent/precursor ratio, and the contact time between them. The activating agent used is a solution of phosphoric acid (50 wt %) in different weight ratios of acid/precursor of 3:1 or 6:1, with resting time of 24 hours. The best support was obtained using a carbonization time of 1 h, a carbonization temperature of 470 , 6:1 precursor/acid ratio and 24 hours of resting time. According XRD analysis all samples present amorphous structure of activated carbons with BET surface areas of 1000 to 1400 m /g. With the activated carbons obtained with the best structure and texture, the adsorption of hydrogen and the effects on their meso / microporosity were studied. Said material significantly improved H storage behaviour compared to CMK-3 type nanostructured carbon (3.1% by weight at -196,15 C and 10 bar). The synthesized material shows promise in absorbing hydrogen by weak binding forces (physisorption).Item Orange peel biowaste used as a nanoscopic hydrogen reservoir(2022) Juárez, Juliana María; Ledesma, Brenda; Anunziata, Oscar Alfredo; Gómez Costa, Marcos Bruno; Beltramone, Andrea RaquelThis work addresses the bio-waste vaporization approach for the development of a novel carbonaceous nanomaterial to be used in the adsorption of hydrogen as an alternative in the use of green hydrogen. In this research, activated carbons were synthesized from orange peel using different synthesis conditions. With the activated carbons obtained with the best structure and texture, the adsorption of hydrogen and the effects on their meso / microporosity were studied. The activation of the carbon was carried out by means of a chemical process with phosphoric acid as activating agent, varying the acid concentration, the substrate / activating agent ratio, and the contact time between them. The best support was obtained using a carbonization time of 1 h, a carbonization temperature of 470oC, a phosphoric acid concentration of 50% by weight and a BET area of 1402 m2 / g. Said material significantly improved H2 storage behaviour compared to CMK-3 type nanostructured carbon (3.1% by weight at -196,15 oC and 10 bar). The synthesized material shows promise in absorbing hydrogen by weak binding forces (physisorption).Item Nanoscopic hydrogen reservoir orange peel biowaste(2022) Juárez, Juliana María; Ledesma, Brenda Cecilia; Anunziata, Oscar A.; Gómez Costa, Marcos Bruno; Beltramone, Andrea RaquelThis work addresses the bio-waste valorization approach for the development of a novel carbonaceous nanomaterial to be used in the adsorption of hydrogen as an alternative in the use of green hydrogen. In this research, activated carbons were synthesized orange peel using different synthesis conditions. With the activated carbons obtained with the best structure and texture, the adsorption of hydrogen and the effects on their meso / microporosity were studied. The activation of the carbon was carried out by means of a chemical process with phosphoric acid as activating agent, varying the acid concentration, the substrate / activating agent ratio, and the contact time between them. The best support was obtained using a carbonization time of 1 h, a carbonization temperature of 470oC, a phosphoric acid concentration of 50% by weight and a BET area of ??1402 m2 / g. Said material significantly improved H2 storage behaviour compared to CMK-3 type nanostructured carbon (3.1% by weight at -196,15 oC and 10 bar). The synthesized material shows promise in absorbing hydrogen by weak binding forces (physisorption).Item Iron-modified mesoporous materials as catalysts for ODS of sulfur compounds(2020) Rivoira, Lorena Paola; Juárez, Juliana María; Martínez, María Laura; Beltramone, Andrea RaquelFe-modified mesoporous catalysts were used in the ODS of DBTs using H2O2 as oXidant and acetonitrile as solvent. SBA-15, MCM-48, CMK-3 and CMK-1 were used as supports. Iron was incorporated using iron nitrate by wetness impregnation. The catalysts were characterized by XRD, N2 isotherms, TEM, XPS and ICP. We developed catalysts with high specific surface area, pore volume and narrow mesopore size distribution and highly dis- persed Fe- species. The catalysts were tested in the o Xidative desulfurization of different sulfur compounds as benzothiophene, dibenzothiopene and 4,6-dimethyl dibenzothiopene. The catalyst prepared using CMK-3 as support was the most active for the ODS reaction. The good activity was related with the high dispersion of the iron oXides, mainly in the magnetite phase. Temperature, hydrogen peroXide and sulfur initial concentration were studied using Fe-CMK-3 in the oXidation of DBT. The optimal operation conditions were determined. Fe- CMK-3 is an active and stable catalyst to be applied in the industrial process of ODS.Item Short time synthesis of titania modified-CMK-3 carbon mesostructure as support for Ir-catalyst applied in catalytic hydrotreating(2020) Ledesma, Brenda Cecilia; Juárez, Juliana María; Beltramone, Andrea RaquelTi-CMK-3 carbon mesoporous was prepared using a novel synthesis method. This new method avoids the hard template synthesis used commonly. The method developed here, allows to reduce time, energy consumptionand cost. Structural and textural characterization of the titanium modified-mesoporous carbonwas performed by N2 adsorption, XRD, UV–vis-DRS, Raman spectroscopy and TEM. The characterization results indicated that the textural and structural properties of the material synthesized by the short time method are comparable with the properties of the material prepared by the hard template method. Ti modi fied-mesoporous carbon was used as support of the iridium nanoparticles, in order to prepare a catalyst to be tested in model hydrotreating reactions. The catalyst obtained by wet impregnation with iridium acetylacetonate were characterized by ICP -AES, H2 chemisorption, TEM, XPS and FTIR of adsorbed pyridine. The high Ir dispersion and small particle size, along with the moderate Lewis acidity generated by the presence of titanium in the support, were responsible for the good performance and stability of the catalyst in the hydrogenation of tetralin in presence of nitrogen com - pounds. Main advantage of the present study is the reduction of time and cost in the synthesis of the new material and the applicability for HDT reactions.Item Influence of ti incorporation to bimetallic mesoporous carbon in the production of 2,5‑dimethylfuran from biomass derivatives(2021) Ledesma, Brenda Cecilia; Juárez, Juliana María; Domine, Marcelo E.; Beltramone, Andrea RaquelMonometallic and bimetallic supported catalysts were developed to produce 2,5-dimethylfuran (DMF) trough hydrogenolysis of 5-(hydroxymethyl)furfural (HMF). Detailed physicochemical characterization was done to understand structure–activity correlation. Through a series of experiments and comparatives tests, the synergistic effect among Pt, Ir, and Ti incorporated in the support was investigated. Results revealed that using the titanium contained ordered mesoporous carbon, synthesized by a novel technique, high selectivity to DMF was achieved. In the case of the best catalyst PtIr-TiC, the good activity and excellent selectivity to the desired product DMF (98% yield) was related to the high hydrogenating capacity of the bimetal- lic sites, the acid support characteristics and the high metal nanoparticles dispersion achieved on the mesoporous titanium modified carbon support.Item Sustainable utilization of orange peels waste for preparation of activated carbon: synthesis, characterization and hydrogen storage application(2022) Juárez, Juliana María; Anunziata, Oscar Alfredo; Gómez Costa, Marcos Bruno; Beltramone, Andrea Raquel; Ledesma, Brenda CeciliaThe recovery and reuse of orange peel waste (OP) is a sustainable strategy in a circular economy. In this research, OP was used as the raw material for the preparation of a novel carbonaceous nanomaterial to be used in the adsorption of hydrogen as an alternative in the use of green hydrogen. Activated carbons were synthesized from orange peel using different synthesis conditions. The activation of the carbon was carried out by means of a chemical process with phosphoric acid as activating agent, varying the the activating agent/precursor ratio, and the contact time between them. The activating agent used is a solution of phosphoric acid (50 wt %) in different weight ratios of acid/precursor of 3:1 or 6:1, with resting time of 24 hours. The best support was obtained using a carbonization time of 1 h, a carbonization temperature of 470oC, 6:1 precursor/acid ratio and 24 hours of resting time. According XRD analysis all samples present amorphous structure of activated carbons with BET surface areas of 1000 to 1400 m2/g. With the activated carbons obtained with the best structure and texture, the adsorption of hydrogen and the effects on their meso / microporosity were studied. Said material significantly improved H2 storage behaviour compared to CMK-3 type nanostructured carbon (3.1% by weight at -196oC and 10 bar). The synthesized material shows promise in adsorbing hydrogen by weak binding forces (physisorption).Item Sustainable utilization of orange peels waste for preparation of activated carbon: Synthesis, Characterization and Hydrogen storage application(2022) Juárez, Juliana María; Ledesma, Brenda Cecilia; Beltramone, Andrea Raquel; Gómez Costa, Marcos Bruno; Anunziata, Oscar AlfredoThe recovery and reuse of orange peel waste (OP) is a sustainable strategy in a circular economy. In this research, OP was used as the raw material for the preparation of a novel carbonaceous nanomaterial to be used in the adsorption of hydrogen as an alternative in the use of green hydrogen. Activated carbons were synthesized from orange peel using different synthesis conditions. The activation of the carbon was carried out by means of a chemical process with phosphoric acid as activating agent, varying the the activating agent/precursor ratio, and the contact time between them. The activating agent used is a solution of phosphoric acid (50 wt %) in different weight ratios of acid/precursor of 3:1 or 6:1, with resting time of 24 hours. The best support was obtained using a carbonization time of 1 h, a carbonization temperature of 470oC, 6:1 precursor/acid ratio and 24 hours of resting time. According XRD analysis all samples present amorphous structure of activated carbons with BET surface areas of 1000 to 1400 m2 /g. With the activated carbons obtained with the best structure and texture, the adsorption of hydrogen and the effects on their meso / microporosity were studied. Said material significantly improved H2 storage behaviour compared to CMK-3 type nanostructured carbon (3.1% by weight at -196,15 oC and 10 bar). The synthesized material shows promise in absorbing hydrogen by weak binding forces (physisorption)