Síntesis y caracterización de mof uio-66 con solventes amigables

Abstract

El estudio de los compuestos metal-orgánicos MOFs ha experimentado un rápido crecimiento en las últimas dos décadas debido a sus interesantes propiedades: flexibilidad en cuanto al diseño y funcionalización de sus poros, elevada superficie específica y síntesis menos complejas, entre otras. [1] El objetivo del presente trabajo fue sintetizar compuestos del tipo MOF UIO-66 con circonio (Zr) como precursor metálico y tetracloruro de circonio como fuente metálica, empleando una ruta alternativa de síntesis, con condiciones más favorables desde el punto de vista económico y ambiental. Es por ello que se propone el uso de solventes alternativos. La síntesis se realizó mediante el método solvotermal a 120 ºC durante 24hs. Se utilizó dimetilformamida (DMF) como solvente y se reemplazó entre un 0 y 75%, de dicho solvente, por acetona. Las propiedades del material fueron caracterizadas por difracción de rayos X (DRX), microscopía electrónica de barrido (SEM-EDS), espectroscopia infrarroja (FTIR) y área superficial. El MOF obtenido mediante la síntesis con 100% de DMF mostró las mejores propiedades cristalográficas, morfológicas y la mayor área superficial. El reemplazo del contenido del solvente generó pequeños cambios en la estructura y morfología de los MOF.
The study of the metal-organic frameworks MOFs has experienced a rapid growth in the last two decades due to its interesting properties: flexibility in the design and functionalization of its pores, high specific surface and less complex synthesis, among others. [1] The objective of this work was to synthesize compounds of the MOF type UIO-66 with zirconium (Zr) as a metallic precursor and zirconium tetrachloride as a metallic source, using an alternative route of synthesis, with more favorable conditions from the economic and environmental point of view. That is why the use of alternative solvents is proposed. The synthesis was carried out by the solvothermal method at 120 ºC for 24 hours. Dimethylformamide (DMF) was used as the solvent and between 0 and 75% of said solvent was replaced by acetone. The properties of the material were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM-EDS) and infrared spectroscopy (FTIR) y superfical area. The MOF obtained by synthesis with 100% DMF showed the best crystallographic, morphological properties and the largest superfical area. The replacement of the solvent content generated small changes in the structure and morphology of the MOF.

Description

Keywords

Materiales porosos, Red metal-orgánica (MOF), UIO-66, solvotermal, Circonio

Citation

Endorsement

Review

Supplemented By

Referenced By

Creative Commons license

Except where otherwised noted, this item's license is described as openAccess